Millmate Controller 400 has been designed to offer a lot of functionalities and at the same time a high degree of user-friendliness.
The control unit covers all edge sensor installation possibilities. This means the user only has to follow the step-by-step instructions in order to set up the control unit and to have correct strip edge and center position and width calculated.
- Calculates true strip position and width in relation to the mill
- Filter times from 10 ms
- Easily configurable analog/digital inputs/outputs
- Digital edge position level detectors
- Digital min. and max. width level detectors
- Unit selection (mm, inch)
- Self-diagnostic test system including continuous edge sensor test
- Simulation mode for easy check of system integration